TM 5-3800-205-23-1
PREPARATION FOR STORAGE OR SHIPMENT
THIS WORK PACKAGE COVERS
Preparation for Short-Term Storage
Preparation for Return to Service from Short-Term Storage
Preparation for Long-Term Storage
Preparation for Return to Service from Long-Term Storage
NOTE
Short-term storage is storage for two weeks or less. Long-term storage is for more than two weeks.
PREPARATION FOR SHORT-TERM STORAGE
1.
Thoroughly clean machine.
2.
Perform Operator Preventive Maintenance Checks and Services (PMCS) (TM 5-3800-205-10-1 or TM 5-3800-205-10-
2).
3.
Fill fuel tank completely to prevent condensation from forming (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
4.
Perform Unit PMCS (WP 0009 00 and WP 0010 00).
5.
Schedule next PMCS on ULLS-G (Unit Level Logistics System Ground).
6.
Store machine indoors in a dry, protected area with scraper bowl/tank lowered to the ground (TM 5-3800-205-10-1 or
TM 5-3800-205-10-2).
7.
When moderate temperatures are expected, leave batteries in place. If extreme cold is expected, remove batteries
8.
Check engine coolant to ensure coolant has correct mixture for expected temperatures (TB 750-651).
9.
10.
Ensure battery disconnect switch is in OFF position (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
11.
Fill in Form DD 1397 completely and attach to a conspicuous part of machine.
12.
Drain water tank and water pump (water distributor only).
PREPARATION FOR RETURN TO SERVICE FROM SHORT-TERM STORAGE
1.
Remove seals from all engine openings, including air intake, exhaust outlet, and crankcase breather tube.
2.
If removed, install batteries (WP 0067 00).
3.
Check oil and hydraulic fluid levels in engine crankcase, transmission, front axle differential, wheel end final drives,
and hydraulic tank (PMCS in TM 5-3800-205-10-1 or TM 5-3800-205-10-2 and Unit PMCS in TM 5-3800-205-23-1).
4.
Check coolant level in radiator (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
5.
Start engine and perform machine warmup (TM 5-3800-205-10-1 or TM 5-3800-205-10-2). Verify proper operation of
all gages, switches, and EMS indicator and warning lights.
6.
Ensure fuel tank is full (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
7.
Operate machine without a load and check engine, transmission, brakes, steering, and electrical accessories for proper
operation (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
