TM 5-3800-205-23-2
FUEL/WATER SEPARATOR REPLACEMENT - CONTINUED
0002 00
REMOVAL
1.
Clean area around fuel/water separator filter housing (8) and fuel/water separator head (3).
2.
Unscrew retaining ring (10) and remove fuel/water separator filter housing (8) from fuel/water separator head (3).
3.
Remove filter element (9) from fuel/water separator filter housing (8). Discard filter element.
4.
Disconnect hose (1) from connector at fuel/water separator head (3). Remove O-ring (2) from hose and discard. Install
protective cap on hose.
5.
Remove tee (6) and O-ring (7) from connector at fuel/water separator head (3). Install protective cap on tee. Discard O-
ring.
6.
Remove two screws (4), washers (5), and fuel/water separator head (3) from rear of scraper.
7.
Remove two connectors, two plugs, and four O-rings from fuel/water separator head (3). Discard O-rings.
6,7
3
4,5
1,2
10
9 (HIDDEN)
8
390-1270
INSTALLATION
NOTE
Coat new O-rings with clean fuel before installation.
1.
Install four new O-rings, two connectors, and two plugs on fuel/water separator head (3).
2.
Install fuel/water separator head (3) on rear of scraper with two washers (5) and screws (4).
3.
Remove protective cap from tee (6). Install new O-ring (7) and tee to connector on fuel/water separator head (3).
4.
Remove protective cap from hose (1). Install new O-ring (2) and connect hose to connector on fuel/water separator head
(3).
5.
Install new filter element (9) in fuel/water separator filter housing (8).
0002 00-2
