TM 5-3805-248-23-1
LIGHTING SYSTEM TROUBLESHOOTING PROCEDURES - CONTINUED
0012 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
Cutting Edge Worklight Is
c. Set multimeter to appropriate
voltage range (WP 0018 00).
Inoperative - Continued.
d. Connect multimeter positive lead to
terminal on cutting edge worklight
relay that green wire was removed
from (relay side) and multimeter
negative lead to chassis ground.
394-1582
e. Place battery disconnect switch in
ON position (TM 5-3805-248-10).
f. Place light switch in SER DRIVE
1. If battery voltage is indicated, repair
position.
open circuit between cutting edge
worklight and cutting edge worklight
relay (WP 0018 00).
2. If battery voltage is not indicated, go to
Test 4.
4.
Check for voltage to cutting edge
worklight relay.
a. Place battery disconnect switch in
OFF position (TM 5-3805-248-10).
0012 00-8
