TM 5-3805-248-23-1
LIGHTING SYSTEM TROUBLESHOOTING PROCEDURES - CONTINUED
0012 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
Cutting Edge Worklight Is
b. Connect multimeter positive lead to
wire on cutting edge worklight and
Inoperative - Continued.
multimeter negative lead to chassis
ground.
394-1581
c. Place battery disconnect switch in
ON position (TM 5-3805-248-10).
d. Place light switch in SER DRIVE
1. If battery voltage is indicated, replace
position.
cutting edge worklight (WP 0086 00).
2. If battery voltage is not indicated, go to
Test 3.
3.
Check for voltage from cutting edge
worklight relay.
a. Place battery disconnect switch in
OFF position (TM 5-3805-248-10).
b. Disconnect green wire from cutting
edge worklight relay (WP 0078 00).
0012 00-7
