TM 5-3805-248-23-1
FUEL LINES REPLACEMENT - CONTINUED
0035 00
REMOVAL - CONTINUED
24.
Disconnect hoses (42 and 48) from elbows (45 and 39).
25.
Remove elbows (45 and 39) and preformed packings (40 and 41). Discard preformed packings.
26.
Remove hoses (42 and 48) from elbows (47 and 43).
27.
Remove elbows (47 and 43) and preformed packings (44 and 46) from fuel injection pump. Discard preformed pack-
ings.
40
39
41
42
48
43
47
45
44
46
394-028
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
1.
Clean all parts with solvent cleaning compound.
2.
Dry all parts with compressed air.
3.
Inspect all parts for damage and replace as necessary.
0035 00-5
