TM 5-3805-248-23-1
AIR COMPRESSOR REPLACEMENT - CONTINUED
0167 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Remove gasket material from all mating surfaces.
2.
Clean all parts with solvent cleaning compound.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
INSTALLATION
1.
Install governor (WP 0168 00).
2.
Apply a thin coat of lubricating oil to lip of new seal (9) and install in crankshaft of air compressor assembly (3).
3.
Apply a thin coat of lubricating oil to accessory drive bore where the air compressor assembly (3) contacts accessory
drive.
4.
Position new gasket (10) on compressor assembly (3).
CAUTION
Do NOT use anti-seizing tape on oil line connections. Use sealing compound instead. Anti-seizing tape can
deteriorate and contaminate the oil system causing premature failure.
NOTE
Apply anti-seizing tape half way up the threads of all AIR AND COOLANT hose and fitting connec-
tions prior to installation to ensure correct sealing.
Apply sealing compound to the threads of all OIL hose and fitting connections prior to installation to
ensure correct sealing.
5.
Install four elbows (5), elbow (8), connector (6) and tee (7) on air compressor assembly (3).
0167 00-4
