TM 5-3805-248-23-1
DRAFT FRAME HOSES, LINES AND FITTINGS REPLACEMENT - CONTINUED
0236 00
INSTALLATION - CONTINUED
12.
13.
Install six clamp halves (4) and three spacers (3) on tube assemblies (9, 10 and 11).
14.
Install six sleeves (2) and capscrews (1).
15.
Install two clamps (7 and 8), four washers (6) and capscrews (5) on tube assemblies (9, 10 and 11).
1,2
3,4
5,6
7
5,6
394-547
10 9 8
11
16.
Refill hydraulic tank to correct level (TM 5-3805-248-10).
17.
Start engine (TM 5-3805-248-10).
WARNING
Only a qualified operator may perform the following procedure. All other personnel must clear the immedi-
ate area of the vehicle. Failure to follow this warning may cause injury. If you are injured, obtain medical aid
immediately.
NOTE
If hose or tube assemblies were removed from a certain system, such as the ejector, operate only the ejector
control. If hose or tube assemblies were removed from all systems, operate all the controls to complete the
next procedure.
18.
Operate hydraulic controls. Move each system through at least five full movements of travel to bleed air out of system.
19.
Shut down engine (TM 5-3805-248-10).
20.
Check oil level in hydraulic tank and add if necessary (TM 5-3805-248-10).
21.
Inspect all hose and tube assemblies for leaks (TM 5-3805-248-10).
END OF WORK PACKAGE
0236 00-6