TM 5-3805-248-23-2
FUEL INJECTION PUMP HOUSING AND GOVERNOR REPLACEMENT - CONTINUED
0273 00
REMOVAL - CONTINUED
6.
Remove five bolts (9) from pump housing and governor assembly (4).
7.
Remove two bolts (10), preformed packing (11) and gasket (12) from governor drive. Discard gasket and preformed
packings.
8.
Remove bolt (5) which was loosened in step 5.
9.
Remove fuel injection pump housing and governor assembly (4) from machine.
7,8
9
4
394-482
10
12 (HIDDEN)
11 (HIDDEN)
INSTALLATION
1.
Attach lifting device to fuel injection pump housing and governor assembly (4).
2.
Install new gasket (12), two new preformed packings (11), fuel injection pump housing and governor assembly (4) and
two bolts (10) on machine.
3.
Install five bolts (9) in pump housing and governor assembly (4).
4.
Install washer (3), bracket (6), washers (2), four bolts (1) and bolt (5) on pump housing and governor assembly (4).
5.
Connect linkage on governor (WP 0036 00).
6.
Connect fuel injection lines on housing (WP 0030 00).
7.
Start machine and verify normal operation of fuel system (TM 5-3805-248-10).
8.
Shut down engine (TM 5-3805-248-10).
9.
Inspect for fuel system leaks.
10.
Install crankcase guards (WP 0201 00).
11.
Install hood (WP 0180 00).
END OF WORK PACKAGE
0273 00-3/-4 Blank
