TM 5-3805-248-23-2
FUEL INJECTION PUMP AND GOVERNOR ADJUSTMENT - CONTINUED
0274 00
REMOVAL
1.
Remove timing bolt (5), washer (4) and clip from left side of flywheel housing. Leave clip attached to harness.
2.
Remove bolt (6), washer (7), cover (3) and gasket (2). Discard gasket.
3.
Remove plug (1).
1
CLIP
7
6
2
3
394-483
4
5
SETTING
1.
Install engine turning tool through left side of flywheel housing until shoulder of engine turning tool is against flywheel
housing. Engine pinion turning tool engages ring gear on flywheel housing.
2.
Insert 1/2 in. (13 mm) ratchet in engine turning tool.
3.
Position timing bolt (8) and locate against flywheel housing.
NOTE
When direction of engine rotation is specified, engine is viewed from rear.
4.
Rotate 1/2 in. (13 mm) ratchet on engine counterclockwise while holding timing bolt (8) in position and hand tighten.
Stop turning when timing bolt (8) can be threaded into hole in flywheel housing.
0274 00-2
