TM 5-3805-248-23-2
FUEL INJECTION PUMP AND GOVERNOR ADJUSTMENT - CONTINUED
0274 00
ADJUSTMENT - CONTINUED
11
12
394-1696
14.
While engine is running at high idle, loosen locknut (11) and turn adjustment screw (12) to adjust the engine speed to
2300 RPM. If set is out of range, turn the screw in to raise it and out to lower it.
15.
Repeat steps 5 through 12 to recheck set point. When the set point is correct, check the high idle RPM. The high idle
RPM must not be more than 2360.
16.
If the high idle RPM is more 2360, replace the injection pump housing and governor (WP 0273 00).
17.
Shut down engine.
18.
Disconnect battery negative ground from battery box (WP 0104 00).
19.
Remove multitach and injection line speed pickup group from engine.
CAUTION
Follow manufacturer's instructions for removal of test equipment and repainting of fuel injector lines. Fail-
ure to follow this procedure may cause damage to equipment.
20.
Install hood (WP 0189 00).
21.
Install rear crankcase guard (WP 0201 00).
22.
Install muffler (WP 0041 00).
END OF WORK PACKAGE
0274 00-9/-10 Blank
