TM 5-3805-248-23-2
DRIVESHAFT REPLACEMENT - CONTINUED
0293 00
INSTALLATION - CONTINUED
5.
Remove bolt (24) and washer (22) from cover (21).
6.
Loosen clip (18), but do not remove from wiring harness (19).
7.
Remove timing bolt (25), washer (23), cover (21) and gasket (20) from flywheel housing (1). Discard gasket.
19
1
18
25
24
20
394-782
23 22 21
8.
Install engine turning tool in flywheel housing (1) until shoulder of engine turning tool is against flywheel housing.
9.
Attach 1/2 in. (12.7 mm) ratchet on engine turning tool and turn engine in small increments until alignment tool turns
freely through 360 degrees. Remove 1/2 in. (12.7 mm) ratchet and engine turning tool.
1
ENGINE TURNING
TOOL
1/2 IN. RATCHET
394-783
0293 00-7
