TM 5-3805-248-23-2
STEERING CONTROL VALVE MAINTENANCE - CONTINUED
0312 00
REMOVAL
CAUTION
Wipe area clean around all connections prior to removal. Cap hydraulic oil lines and plug openings after
removal. Contamination of hydraulic system could result in premature failure.
NOTE
Use a container to capture draining hydraulic oil. Dispose of hydraulic oil IAW local policy and ordi-
nances. Ensure all spills are cleaned up.
Tag hose and tube assemblies prior to removal to ensure correct installation.
Note routing of all hose assemblies prior to removal to ensure correct installation.
Remove and note location of all clips that secure hose assemblies to ensure correct installation.
1.
Remove three bolts (1) and washers (2) from steering control valve (5).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Steering control valve assembly weighs 52 lb (24 kg).
2.
Install lifting device on steering control valve (5).
3.
Use lifting device to lift steering control valve (5) 4 in.
(10 cm).
1
4.
Disconnect hose assembly (3) from steering control
valve (5).
2
5
5.
Use lifting device to remove steering control valve (5)
from machine.
6.
Remove lifting device from steering control valve (5).
3
394-972
4
0312 00-2
