TM 5-3805-248-23-2
SEAT SUSPENSION ASSEMBLY REPAIR - CONTINUED
0317 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Clean all parts with solvent cleaning compound and dry with compressed air.
2.
Inspect all parts for damage and replace as necessary.
ASSEMBLY
NOTE
All parts furnished in bearing kit will be used to replace like parts during assembly.
1.
Install three bumpers (81) on suspension frame (17)
71
with three new lockwashers (80) and nuts (79).
2.
Position actuator (60) on valve assembly (84).
3.
Install two valve actuator assemblies (83) on actuator
72
(60).
73
74
4.
Install two new bearings (85) and nuts (82) on actuator
70
(60).
75
84
69
76
68
5.
Install two new bearings (74) in retainer (72).
6.
Position bracket (77) on suspension frame (17).
85
7.
Install two screws (73), washers (75) and nuts (76) on
77
retainer (72).
86
83
8.
Position retainer (72) on bracket (77) and install two
78
washers (70), new lockwashers (69) and screws (68).
9.
Position cylinder (71) in retainer (72) and install two
new lockwashers (78) and bolts (86).
82
60
81
17
80
79
394-1035
0317 00-8
