TM 5-3805-248-23-2
SEAT SUSPENSION ASSEMBLY REPAIR - CONTINUED
0317 00
ASSEMBLY - CONTINUED
13.
Position clamp (55) on valve assembly (56).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Accumulator and valve assembly weigh 100 lb (45 kg).
14.
Attach lifting device to valve assembly (56) and accumulator (61) and position valve assembly and accumulator in sus-
pension frame (17).
15.
Install bolt (54), new lockwasher (58) and nut (59) through clamp (55).
16.
Remove lifting device from valve assembly (56) and accumulator (61).
17.
Tighten clamp (57).
18.
Install two new O-rings (51) on two elbows (52).
52
54
19.
Install two elbows (52) on valve assembly (56) and
53
actuator (60).
51
6
20.
Install tube assembly (53) on two elbows (52).
21.
Connect hose assembly (62) to cylinder (6).
55
22.
Install new O-ring (64) on elbow (63) and install
elbow on valve assembly (56).
23.
Connect hose assembly (62) to elbow (63).
56
60
61
58
59
57
64
17
63
62
394-1036
0317 00-10
