TM 5-3805-248-23-2
CYLINDER BLOCK REPAIR - CONTINUED
0342 00
INSPECTION - CONTINUED
16.
Remove liner projection tool group.
17.
Remove two 3/4-16NCx7 bolts, two adapter plates,
LINER PROJECTION
crossbar, puller plate, 14-3/4-16NCx3 bolts and
TOOL GROUP
24-3/4 in. copper flatwashers.
18.
Remove block plate (40) and gasket (41). Discard gas-
ket.
39
FLANGE
394-1112
40
41
19.
Use 5-6 in. inside micrometer to measure bore of cylinder liner (39) near upper limit of wear surface. Remove and dis-
card each cylinder liner (39) that exceeds bore diameter of 5.405 in. (13.73 cm). Perform steps 20 and 21.
NOTE
Steps 20 through 36 must be completed for each cylinder liner seal area that has scaling, pitting or corrosion.
If such defects are not noted, proceed to Assembly in this work package.
20.
Use cylinder liner puller group and adapter plate to remove cylinder liner (39) assembly. Do not scratch or gouge surface
of top deck.
21.
Remove and discard filler band (42) and three preformed packings (43) from cylinder liner (39).
39
39
42
43
394-1114
394-1113
0342 00-7
