TM 5-3805-248-23-2
CRANKSHAFT REAR SEALS REPLACEMENT - CONTINUED
0345 00
INSTALLATION - CONTINUED
9.
Remove nut from stud.
10.
Remove pusher plate and sleeve installer from crankshaft.
11.
Use clean lubricating oil to lubricate lip of new crankshaft rear seal (1) and inside face of washer on nut.
12.
Position new crankshaft rear seal (1) on locator assembly with lip of new seal (1) toward engine.
13.
Slide seal installer and pusher plate on the stud of the locator assembly.
14.
Install nut on stud and tighten until pusher plate is at bottom.
15.
Remove nut, pusher plate, seal installer, three bolts and locator assembly from crankshaft.
LOCATOR
ASSEMBLY
BOLT
1
SEAL INSTALLER
CRANKSHAFT
PUSHER PLATE
WASHER
394-1139
NUT
16.
Install flywheel (WP 0261 00).
17.
Operate engine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0345 00-3/-4 Blank
