TM 5-3805-248-23-2
CRANKSHAFT MAIN BEARINGS MAINTENANCE
THIS WORK PACKAGE COVERS
Center and Intermediate Bearings: Removal, Adjustment, Installation
End Bearings: Removal, Adjustment, Installation
INITIAL SETUP
Maintenance Level
Materials/Parts - Continued
General Support
Tools and Special Tools
Tool kit, general mechanic's (Item 113, WP 0338
Plate, thrust (2)
Shop equipment, machine shop (Item 104, WP
References
Main bearing removal and installation tool (Item
TM 5-3805-248-10
Materials/Parts
Equipment Condition
CENTER AND INTERMEDIATE BEARINGS REMOVAL
1.
Install dial indicator on crankshaft journal number 4.
2.
Adjust contact pin of dial indicator against side edge of crankshaft journal, and adjust dial face so indicator reads zero.
CAUTION
Do not use metal hammer to move crank-
shaft back and forth. Do not contact
machined crankshaft surfaces with metal
pry bar. Failure to follow this procedure
could result in damage to equipment.
3.
While moving crankshaft back and forth, observe dial
indicator to determine end play.
4.
Record end play reading on dial indicator.
5.
Remove dial indicator.
394-1142