TM 5-3805-248-23-2
ROCKER ARMS REPAIR - CONTINUED
0349 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Clean all parts with solvent.
2.
Dry all parts with compressed air.
3.
Inspect all parts for damage and replace as necessary.
ASSEMBLY
NOTE
All rocker arms and brackets must be assembled in original positions.
1.
Install rocker arm (16), plug cup (17), two washers (18) and retaining ring (19) on shaft (20).
2.
Install dowel pin (14) in bracket (13).
1
2
3.
Install bracket (13) assembly, rocker arm (15), spring
3
(12), rocker arm (11), bracket (10), rocker arm (9),
4
spring (8) and rocker arm (7). Bracket (10) does not
5,6
have a dowel pin.
4.
Install dowel pin (6) in bracket (5).
5.
Install bracket (5) assembly, rocker arm (4), plug cup
(3), two washers (2) and retaining ring (1).
394-1174
6.
Install rocker shafts and push rods (WP 0262 00).
7.
Operate engine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0349 00-3/-4 Blank
