TM 5-3805-248-23-2
PISTON AND CONNECTING ROD MAINTENANCE - CONTINUED
0348 00
INSTALLATION - CONTINUED
7.
Put piston into place while assistant guides connecting
rod journal (2) into position on crankshaft.
8.
Use clean lubricating oil to lubricate connecting rod
journal (2), cap (3) assembly and two nuts (1).
9.
Install cap (3) assembly and two nuts (1). Tighten two
nuts (1) to 60 lb-ft (81 Nm).
2
1
3
394-1157
10.
Use a paint marker to mark each of two nuts (1) and
5
ends of two bolts (5). Tighten two nuts (1) an addi-
tional 120 degrees.
NOTE
Repeat steps 1 through 21 for the remain-
ing piston and connecting rod sets.
1
394-1173
BOLTS AND
11.
Remove 14 3/4 x 3NF bolts and 28 3/4 in. copper
COPPER WASHERS
washers from top of cylinder block.
394-1156
12.
Install oil pump (WP 0267 00).
13.
Install cylinder head (WP 0259 00).
14.
Install engine (WP 0257 00).
15.
Operate engine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0348 00-12
