TM 5-3805-248-23-2
FUEL INJECTION PUMP REPAIR - CONTINUED
0353 00
ASSEMBLY/ADJUSTMENT - CONTINUED
CAUTION
Exercise care when installing rack bearing. Bearing tab must be centered at top of bore in fuel injection
pump housing. If not centered, governor and fuel injection pump will not operate properly, which could
result in damage to equipment.
8.
Use driver and plate to install new bearing (38) flush with housing face. Center bearing tab at top. Bore 0.5023 + 0.0018
in. (12.75 + 0.045 mm) after installation.
9.
Install new bearing (39) flush with housing face with bearing joint at top. Bore 2.6905 + 0.0015 in. (64.3387 + 0.0381
mm) after installation.
CAUTION
Exercise care when installing rack bearing. Two holes in bearing must be aligned vertically; bearing joint
must be at top of pump housing bore. Failure to follow this procedure could result in damage to equipment.
10.
Using driver and plate, install new bearing (37). Align holes vertically with bearing joint at top. Plate locates bearing at
depth of 0.282 + 0.005 in. (7.1628 + 0.127 mm).
11.
Install new bearing (40). Distance from rear face of housing to bearing 8.6 0.1 in. (122.174 + 0.127 mm) (measurement
A).
12.
Install new bearing (41) flush with face of housing. Bore after installation is 2.6905 + 0.0015 in. (68.3387 + 0.0381 mm)
with bearing joint at top.
37
41
38
40
39
A
B
394-1200
394-997
0353 00-7
