TM 5-3805-248-23-2
FUEL INJECTION PUMP REPAIR - CONTINUED
0353 00
ASSEMBLY/ADJUSTMENT - CONTINUED
17.
Check clearance with 0.007 in. (0.1778 mm) pin gage.
Replace rack (20) if gage can be inserted between rack
(20) and bearing (38).
20
394-1204
38
18.
Assemble plate assembly (33), yoke (34), plate assem-
31
bly (35) and pin (36). Align holes.
19.
Install two pins (31) to secure shaft assembly.
20.
Position shaft assembly on camshaft (28).
21.
Install spring pin (32) through camshaft (28) into slot
28
of yoke (34).
36
35
34
33
32
394-996
CAUTION
Steps 21 through 24 are the procedure to check
camshaft bearing surface wear. Clearance
between camshaft and bearings must not exceed
0.010 in. (0.254 mm). Exercise care when per-
forming this check. Failure to follow this proce-
dure could result in damage to equipment.
22.
Coat camshaft assembly (28) with engine oil.
28
23.
Install camshaft assembly (28) in fuel injection pump
housing.
394-1205
0353 00-9
