TM 5-3805-248-23-2
GOVERNOR ASSEMBLY REPAIR - CONTINUED
0354 00
DISASSEMBLY - CONTINUED
16.
Remove bolt (29) and two bolts (32) from governor
29
assembly (8).
30
17.
Remove two bolts (33) and bolt (31) from governor
31
assembly (8).
NOTE
33
When governor assembly housing is removed
8
from fuel injection pump, parts from inside the
governor assembly will remain attached to the
fuel injection pump.
32
18.
Remove governor assembly (8) from fuel injection
3
pump (3).
394-1217
19.
Remove and discard gasket (30).
WARNING
Some components are under spring tension. Wear eye protection and use caution when disassembling them,
to avoid injury.
20.
Use a spring compressor to compress spring (35) on
34
36
35
rear of fuel injection pump (3).
21.
Remove wave spring (42) and governor spring seat
42
(41) from load stop bolt (45).
41 40
22.
Release spring (35) and remove spring compressor
38
39
from load stop bolt (45).
23.
Remove washers (40, 39 and 34) and spring (35).
24.
Remove three bolts (37), lockring (36) and cylinder
37
assembly (38) from rear of fuel injection pump (3).
3
394-1218
25.
Remove dowel (49) from cylinder assembly (38).
43
44
26.
Remove spring seat (43), governor riser (44) and load
45
stop bolt (45).
46
27.
Remove washer (46), spring (47) and washer (48)
47
from cylinder assembly (38).
48
38
49
394-1219
0354 00-3
