TM 5-3805-248-23-2
TURBOCHARGER REPAIR - CONTINUED
0356 00
ASSEMBLY - CONTINUED
28.
Remove shaft and wheel assembly (6) from holding
fixture.
6
29.
Turn impeller (7). Impeller (7) should turn freely. If
not, position shaft and wheel assembly (6) in holding
fixture and repeat steps 25 through 29.
7
394-1246
30.
Position shaft and wheel assembly (6) in housing assembly (2) and align match-marks.
CAUTION
To ensure correct housing and clamp installation, lightly tap all around clamp. If clamp assembly comes
loose, housing may impact impeller and cause damage to machine.
31.
Torque nut (8) to 10 lb-ft (14 Nm).
6
32.
Use a soft hammer to tap lightly all around clamp (27)
and torque again to 10 lb-ft (14 Nm).
2
33.
Repeat step 32 until nut (8) does not turn when speci-
fied torque is applied.
27
8
394-1238
0356 00-11
