TM 5-3805-248-23-2
PRESSURE AND SELECTOR VALVE ASSEMBLY REPLACEMENT - CONTINUED
0364 00
REMOVAL - CONTINUED
WARNING
Use adequate hoist and sling for lifting. Failure to follow this procedure may cause injury. If you are injured,
obtain medical help immediately.
CAUTION
Exercise care to keep dust, dirt and other contaminants out of transmission control valve assembly housing.
Make sure hands, clothing and tools are clean. Do not perform this task where wind may carry airborne par-
ticles. Keep parts and case covered with a clean sheet of plastic when left unattended. Failure to follow this
procedure could result in damage to equipment.
NOTE
Weight of cover is 70 lb (32 kg).
18.
Attach lifting device to cover (32).
19.
Use lifting device to remove cover (32).
20.
Remove lifting device.
CAUTION
32
Do not allow gasket material or other con-
47
taminants inside the transmission case.
46
Failure to follow this procedure could
45
result in damage to equipment.
21.
Remove gasket (33) and four plugs (35) from trans-
44
mission case. Discard gasket.
40
43
22.
Remove four bolts (43), washers (42) and two flange
halves (41).
42
23.
Disconnect hose assembly (46) and position out of the
41
way.
24.
Remove four bolts (45), washers (44) and two flange
39
33
halves (34).
25.
Disconnect hose assembly (47) and position out of the
38
way.
37
34
26.
Remove three nuts (38) and lockwashers (37). Discard
27.
Remove bolt (40), lockwasher (39) and manifold
36
assembly (36). Discard lockwasher.
TRANSMISSION
35
CASE
0364 00-4
