TM 5-3805-248-23-2
PRESSURE AND SELECTOR VALVE ASSEMBLY REPLACEMENT - CONTINUED
0364 00
INSTALLATION - CONTINUED
NOTE
Shaft is in FIRST speed position when detent is in the third notch of cam.
36.
Turn shaft (148) until detent (155) is in FIRST speed position on cam (143).
37.
Inspect selector valve assembly (101) spool ends to ensure spool ends are flush with face of valve body. If position is not
correct, complete steps 39 through 44.
NOTE
Steps 39 through 44 are performed only if inspection indicated selector valve assembly spool ends are not in
proper position.
38.
Loosen locknuts (A) on spool ends.
39.
Rotate spools until ends are flush with face of valve body.
40.
Holding spools to prevent them from turning, torque locknuts (A) to 25 lb-ft (34 Nm).
41.
Use 0.060 in. feeler gage to position lever (141) on shaft (148) so it is 0.060 in. from spool link.
42.
Torque nut (136) to 25 lb-ft (34 Nm).
43.
Remove 0.060 in. feeler gage.
136
148
101
141
LOCKNUTS (A)
SPOOL
155
143
ON SPOOL ENDS
LINK
SPOOLS
394-808
0364 00-30
