TM 5-3805-248-23-2
MANUAL SELECTOR VALVE REPAIR - CONTINUED
0369 00
DISASSEMBLY - CONTINUED
CAUTION
Each spool must be tagged after disassembly and must be assembled in the same bore from which it were
removed. Failure to follow this procedure could result in damage to equipment.
4.
Remove four spools (9, 10, 11 and 12) from valve body (4).
5.
Remove screw (8) and plate (7).
8
7
4
9
10
11
12
394-874
CLEANING
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
CAUTION
Do not use dirty cleaning solvent P-D-680 to clean transmission control valve assemblies and parts. Use
only clean, fresh solvent that will leave no residue. Failure to follow this procedure could result in damage to
equipment.
0369 00-2