TM 5-3805-248-23-2
MANUAL SELECTOR VALVE REPAIR - CONTINUED
0369 00
CLEANING - CONTINUED
1.
Remove all seal and preformed packing material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry parts with compressed air.
INSPECTION
CAUTION
All parts are critical to the operation of the transmission control valve assembly and must be inspected
closely. If defective parts are assembled, the transmission will not operate properly, resulting in damage to
equipment.
Inspect all parts and replace if damaged.
ASSEMBLY
CAUTION
Exercise care to keep dust, dirt and other contaminants out of shift pressure valve assembly. Make sure
hands, clothing and tools are clean. Do not assemble these parts where wind may carry airborne particles.
Failure to follow this procedure could result in damage to equipment.
1.
Install plate (7) and screw (8) in valve body (4).
2.
Use clean lubricating oil to lubricate spools (9, 10, 11 and 12) and install. Be sure to install in the same bore from which
they were removed.
3.
Install three nuts (3) on links (2).
4.
Install three links (2) in valve body (4).
5.
Install three pins (1) in links (2).
6.
Install nut (5) on link (6).
7.
Install link (6) in valve body (4).
8.
Adjust nuts (5 and 3) so that links (6 and 2) are in the same position.
2
1
4
3
6
5
394-872
9.
Install manual selector valve in transmission (WP 0364 00).
10.
Operate machine to verify correct transmission operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0369 00-3/-4 Blank
