TM 5-3805-248-23-2
DIFFERENTIAL AND BEVEL GEAR REPAIR - CONTINUED
0376 00
ASSEMBLY - CONTINUED
44.
Install bearing cap (41), two washers (46) and nuts
38
39
(47). Torque nuts to 640 lb-ft (868 Nm).
42
40
45.
Install bearing cap (44), two washers (43) and nuts
48
41
43
(42). Torque nuts to 640 lb-ft (868 Nm).
47
46
44
45
394-1480
46.
Install rings (34 and 45). Turn rings (34 and 45) clockwise to secure.
47.
Attach lifting device to differential and ring (34) as an assembly.
48.
Use lifting device to position differential assembly so that axle center line is vertical and gear (61) is on the bottom.
NOTE
Ring gear backlash is measured between gears (61 and 74). Backlash should be 0.0140.005 in.
(0.3560.127 mm). To adjust, rotate rings (34 and 45) in the same direction and same amount to get the
correct backlash.
49.
Use dial indicator to adjust gear (61) backlash.
NOTE
Preload bearing (55) with use of a dial indicator. Measure between ring (34) and gear (61). To preload,
increase dimension by 0.0070.002 in. (0.1780.051 mm). Check gear backlash and adjust if necessary.
50.
Use dial indicator to preload bearing (55).
34
55
51.
Adjust gear (61), if necessary.
(HIDDEN)
52.
Position differential assembly upright.
74
53.
Remove lifting device.
(HIDDEN)
61
394-1499
0376 00-22
