TM 5-3805-248-23-2
EJECTOR CYLINDER REPAIR - CONTINUED
0384 00
ASSEMBLY - CONTINUED
14. Use clean engine oil to coat inside of cylinder (6).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Weight of ejector cylinder is 725 lb (329 kg).
3
15.
Use lifting device to install cylinder (6) over rod
assembly (3).
16.
Remove lifting device.
6
394-1438
17.
Extend rod (3) to its farthest length of travel.
18.
Install two washers (1) and bolts (2).
19.
Install six washers (5) and bolts (4).
1
2
5
3
4
394-1437
20.
Install ejector cylinder (WP 0234 00).
21.
Operate machine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0384 00-7/-8 Blank
