TM 5-3805-260-10
(8)
Remove both bolts from the straps located
on both sides of the ejector hinge.
(9)
Fold ejector down and reinstall the straps.
WARNING
Stand outside of bowl area on the steps while
performing the following item. Personal injury
could result from the ejector moving forward.
(10) Start engine. Move ejector into position
and attach links to the ejector using the
clevis pins (access from steps on the side
of the bowl). Stop engine.
WARNING
Do not place hands at the end of the elevator
hanger arm near the pin joint with the
bowlside. A possible pinch point exists which
could result in personal injury.
(11) Remove the bolt from rear end of the
elevator hanger arm pin and remove the
nut from the pin. Drive the pin out of the
hanger arm on both sides by inserting rod
through the holes in the bowlside.
NOTE
Elevator will drift rearward with ejector control
lever in neutral. To stop drift, move ejector
control
lever
slightly
into
"ejector
open"
position.
1-52
