TM 5-3805-260-10b.PreparationForOperation. The following procedures describe the steps necessary to prepare the machine forwork after air transport.(1)On each side of bowl fold down the step.(2)Remove material used to strap ejector tobowl sides.(3)Start the engine. Move the ejector forwardto raise the elevator. Open the moveablefloor.WARNINGDo not place hands at the end of the elevatorhanger arm near the pin joint with the bowlside.A possible pinch joint exists which could resultin personal injury.(4)Install both top elevator hanger arms onthe pivot shafts. The ejector may have tobe moved to do this. Use caution ifmovement is required.(5)Drive pins into hanger arm on both sides.Attach bolt to the rear end of the elevatorhanger arm pin.WARNINGStand outside of bowl area on the steps whileperforming the following step. Personal injurycould result from the ejector moving forward.1-57
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
