TM 5-3805-260-10
6.
Install the new filters by hand. When the seal
contacts the base, tighten an additional 3/4 turn.
CAUTION
Do not overtighten the filters.
Use the index marks on the filter as a guide for proper
tightening.
7.
Install the crankcase drain plug. Install the access
plate.
9.
Install the fill plug. Start the engine and operate at
low idle.
10.
Check for leaks.
11.
Stop the engine. Check the oil level.
22
Brake Master Cylinders
Remove the fill plugs from the tractor and the scraper
brake master cylinders. Keep the fluid level to the
bottom of the plug openings. Install the plugs.
8.
Raise and block the hood. Remove the fill plug. Fill
the crankcase with oil. See Refill capacities.
12.
Keep the level between the ADD and FULL marks
on the dipstick. Close and secure the hood.
The scraper master cylinder is located under the plate at
the rear of the scraper.
2-30
