TM 5-3805-260-24GAUGE INSTALLEDTypical Example1. 3B7722 Bushing 2. 9S8138 Pressure GaugeThe front housing has several plugs that give access towater passages inside the housingDYNAMOMETER TEST CAUTIONTo prevent possible damage to an engine whiletesting on a dynamometer, the water temperatureregulators must be installed and shunt line (2) connectedas shown.SHUNT LINE CONNECTED TO ENGINE(Typical Example)1. FT790 Cooling Tower Group. 2. Shunt Line.BASIC BLOCKCONNECTING RODS AND PISTONSUse the 5F9059 Piston Ring Expander to remove orinstall piston rings.Use the 5P3524 Piston Ring Compressor to installpistons into cylinder block.Tighten the connecting rod nuts in the following stepsequence:1.Put engine oil on bolt threads and seatingsurfaces of cap and nut.2.Tighten both nuts to 30 +3 lb. ft. (40 +4Nm3.Put a mark on each nut and cap.4.Tighten each nut 600 from the mark.The connecting rod bearings should fit tightly in thebore in the rod. If bearing joints or backs are worn(fretted), check for bore size as this is an indication ofwear because of looseness.2-72
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business