TM 5-3805-260-24 GOVERNOR CONTROL LEVER AT: PRESSURE PRESSURE TAP MINIMUM SETTING MAXIMUM SETTING ADJUSTMENT LOCATION Pump (F) 260 psi (18.3 kg/cm²) (1793 kPa) 310 15 psi (21.8 1.1 kg/cm²) NONE.  Adjustment is Filter Cover Minimum.  Check in all forward and (213 7 103 kPa).  Check in all controlled by the reverse speeds. forward and reverse speeds. modulation relief valve. Speed Clutch (D) P1 73 3 psi (5.1 0.21 kg/cm²) (503 Add or remove spacers (Primary Pressure Control 21 kPa) with selector lever in (21) behind modulation Setting) Valve NEUTRAL. relief valve (2).  See spacer chart. Speed Clutch (D) P1 260 psi (18.3 kg/cm²) (1 793 kPa) 310 15 psi (21.8 ± 1.1 kg/cm²) NONE.  Adjustment is Pressure Control Minimum.  Check in all forward and (2137 ± 103 kPa).  Check in all controlled by the Valve. reverse speeds. forward and reverse speeds. modulation relief valve. Direction (E) P2 50 8 psi (3.5 0.621 kg/cm²) (345 50  8 psi (3.5 0.6 kg/cm²) (345 NONE. Clutch Pressure Control 55 kPa) less than the pressure of ± 55 kPa) less than the pressure of Valve the speed clutch.  Check in all the speed clutch.  Check in all forward and reverse speeds. forward and reverse speeds. Transmission (C) 1 psi (0.1 kg/cm²) (7 kPa) 10 3 psi (0.7 0.2 kg/cm²) (69 NONE. Lubrication On transfer Minimum.  Check in all forward and 21 kPa). Check in all forward and Oil gear case reverse speeds. reverse speeds. Outlet from (B) 2 psi (0.1 kg/cm²) (14 kPa) 40 ± 5 psi (2.8 0.4 kg/cm²) (276 NONE. the Torque On converter Minimum with selector lever in 35 kPa) with selector lever in Controlled by Converter housing near THIRD SPEED forward,  brakes THIRD SPEED forward,  brakes orifice. outlet line to activated and converter stalled. activated and converter stalled. oil cooler Inlet to the (A) P3 1 125 psi (8.1 kg/cm²) (793 kPa) NONE. Torque Pressure Control Maximum. Converter: Valve BENCH TEST for correct operation 2-100