TM 5-3805-260-24FUEL INJECTION PUMP HOUSING3.Put shaft (4) in the housing. Slide sleeve levers(6) and lever (5) on to the shaft in the sequenceshown. Push the shaft into position in the hous-ing.4.Install the screw that holds lever (5) to the shaft.Tighten the screw to a torque of 24 + 2 lb. in. (2.8.2 N m).5.Put shaft assembly (7) in the housing. Slidesleeve levers (9) and lever assembly (8) on to theshaft in the sequence shown. Push the shaft as-sembly into position in the housing.6.Install the screw that holds lever assembly (8) tothe shaft assembly. Tighten the screw to a torqueof 24 + 2 lb.in. (2.8 +0.2 N.m).end by:a)make adjustments to the sleeve control shafts(see TESTING AND ADJUSTING)b)install fuel transfer pumpc)assemble governord)install fuel injection pumps3-81
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business