TM 5-3805-260-24
GOVERNOR
23.
Put 5S1454 Sealing Compound on the outside diameter of the
seal. Use tool group (D) to install the seal in governor housing
assembly (31) with the lip of the seal toward the inside as
shown. Remove the sealing compound from housing
assembly (31) after the seal is installed.
24. Put the lever assembly, spring (36) and lever (32) in position on
shaft assembly (33). Put 9M3710 Anti-Seize Compound on the
outside diameter of the spacer and install the spacer and bolt (34)
to hold lever (32) in position.
25. Put lever assembly (38) in position in housing assembly (31) with
washers (35) and (37) on each side of the lever assembly.
26. Install shaft assembly (33) in housing assembly (3 1) and install the
two bolts to hold lever assembly (38) to the shaft assembly.
27. Install seat (39), springs (40) and (41 ) in housing assembly (31).
CAUTION: Both springs must make full contact on seat (39) before they
are installed in the governor hous- ing assembly. If the springs do not
make full contact on the seat, high idle speed will not be correct and
low idle governor surge can be the result. Low idle setting without
stability can also result.
28.
Install the gasket and housing assembly (31) on
the fuel injection pump housing.
29.
Remove the fuel injection pump housing from
tool (A).
end by:
a)
make an adjustment of the fuel system setting
(See FUEL SYSTEM in TESTING AND
ADJUSTING)
b)
install fuel injection pump housing and gov-
ernor
3-77
