TM 5-3805-260-24GOVERNOR22.Disassemble the fl)weight assembly as follows:a)Remove shaft (40) from carrier (41).b)Remove dowel (39) from shaft (40).c)Remove dowels (43) and weights (42) from carrier (41).ASSEMBLE GOVERNORTools NeededABCDE2P8315Bracket Assembly13P1544Timing Pin15P301Driver11P510Driver Group11P1855Pliers11.Assemble the flyweight assembly as follows:a)Put weights (4) in position on carrier (3) andinstall dowels (5) to hold the weights.b)Install dowel (1) in shaft (2).c)Install shaft (2) in carrier (3).2.Install the fuel injection pump housing in tool (A).3.Install tool (B) to hold the camshaft.4.Put the flyweight assembly in position on the camshaft.NOTE: Be sure the pin that holds the flyweight shaft is inposition in the back of the flyweight carrier before thebolts are installed.5.Install bolts (6) that hold the flyweight assembly to the camshaft. Tighten the bolts to a torque of 10 -+ ’ lb. ft. (14 + 3 N m).6.Remove tool (B) from the fuel injection pumphousing.7.Put shield (7) in position over the flyweights.3-74
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business