TM 5-3805-260-24 FUEL TRANSFER PUMP INSTALL FUEL TRANSFER PUMP Tools Needed A B C D 1P529 Handle 1 1 1P463 Drive Plate 1 5P318 Drive Plate 1 5P319 Drive Plate 1 S1603 Bolt (½” - 20 NF x 1 ½” long) 1 484280 Washer 1 3P1544 Timing Pin 1 1. Install key (1) and drive gear (2) on the shaft. 2. Put  5S  1454  Sealing  Compound  on  the  outside of the seals. 3. Install the inner seal in the body with the lip of the seal toward the inside with tooling (A). 4. Install the outer seal in the body with the lip of the seal toward the outside with tooling (B). 5. If necessary, install new dowels in the body until they extend .2 in.  (5.08 mm) from the inside surface. 6. Remove  the  extra  sealing  compound  from  the body and the seals after installation. 7. Install  O-ring  seal  (4)  and  idler  gear  (3)  in  the body. 8.    Install body (5) on the housing. 3-69