TM 5-3805-260-24
FUEL TRANSFER PUMP
9.
Install four bolts (7) that hold the body to the
housing.
10.
Put tool (D) in position so the camshaft will not
turn.
1.
Put sleeve (6) on the camshaft.
12.
Tighten the sleeve into position on the shaft with
4B4280 Washer of tooling (C) approximately’
.25 in. (6.4 mm). Tighten the sleeve the
remainder of the way with the 4N337’1- Washer
until the sleeve is at bottom. This is the washer
which is on the tachometer drive shaft
CAUTION: Do not hit the sleeve to instal1. Damage to
governor will result.
13.
The end play of the camshaft must be .023 +
.018
in. (0.58 - 0.46 mm) after sleeve (6) is
installed.
end by:
a)
install fuel injection pump housing and
governor
3-70
