TM 5-3805-260-24
WATER PUMP
REMOVE WATER PUMP
start by:
a)
remove fan and fan drive
1.
Drain the coolant from the cylinder block.
2.
Loosen belt tighteners (1) and (2) and remove
the three vee belts from the water pump.
3.
Remove the four bolts (4) that hold water pump
(3). Remove pointer (5) and the water pump.
INSTALL WATER PUMP
1.
Put the gasket and water pump (I) in position in
the timing gear cover.
2.
Install pointer (3) and bolts (2) that hold the
water pump.
3.
Put the air compressor and water pump vee
belts (6) and (7) in position and make an
adjustment to belt tighteners (4) and (5) to get
the correct belt tension. To get the correct
tension use a tension gauge such as Burroughs
Tool Company Part No. BT-33-96-4- 16 or an
equivalent. The correct gauge indication is 120
+ 5.
end by:
a)
install fan and fan drive
3-97
