TM 5-3805-260-24
ENGINE FRONT SUPPORT
REMOVE AND INSTALL ENGINE FRONT SUPPORT
Tools Needed
A
B
FT1321
Support Beam
1
1H5514
Bolt(5/16"-18NCx 1 5/8in long)
4
8S7630
Stand
1
8S7611
Tube
1
8S7615
Pin
2
8S7625
Collar
1
8S7650
Cylinder
1
5P3100
Pump Group
1
start by:
a)
remove radiator
b)
remove oil pan
1.
Remove the rear oil filter from the engine oil
cooler and put tooling (A) in position under engine.
2.
Put tooling (B) in position under tooling (A) as
shown.
3.
Remove two bolts (I) that hold the support to the
frame.
4.
With tooling (B) lift the engine enough to take the
weight of the engine off of the front support.
5.
Remove four bolts (2) and the washers that hold
support (3) to the timing gear cover.
6.
Remove two bolts (5), the nuts and washers that
hold supports (3) and (6) together.
7.
Remove support (6) and mount assemblies (4).
Remove support (3).
8.
Put support (3) in position and install bolts (2) and
the washers to hold it to the timing gear cover.
9.
Put the lower half of mount assemblies (4) in
position on the tractor frame.
10.
Put support (6) in position and install bolts (5), the
nuts and washers to hold the supports together.
11.
Install the upper half of mount assemblies (4) and
bolts (I).
12.
Lower the engine with tooling (B) and tighten bolts
(1).
13.
Remove tooling (A) and (B) and install the rear oil
filter on the engine oil cooler.
end by:
a)
install oil pan
b)
install radiator
3-115
