TM 5-3805-260-24FLYWHEEL RUNOUTFace Runout (axial eccentricity) of the Flywheel:1.Install the dial indicator as shown Put a force on theflywheel toward the rear.2. Set the dial indicator to read .000 in. (0.0 mm).3.Turn the flywheel and read the indicator every 90°Put a force on the flywheel to the rear before eachreading.4.The difference between the lower and highermeasurements taken at all four points must not bemore than .006 in. (0.15 mm), which is themaximum permissible face runout (axial eccentricity)of the flywheel.Bore Runout (radial eccentricity) of the Flywheel:1.Install the dial Indicator (3) and make an adjustmentof the universal attachment (4) so it makes contactas shown.2. Set the dial indicator to read .000 in. (0.0 mm).3. Turn the flywheel and read the indicator every 900.4.The difference between the lower and highermeasurements taken at all four points must not bemore than .006 in. (0.15 mm), which Is themaximum permissible bore runout (radialeccentricity) of the flywheel.5.Runout (eccentricity) of the bore for the pilot bearingfor the flywheel clutch, must not exceed .005 in.(0.13 mm).1-29
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
