TM 5-3805-260-24
STEERING LINKS
3.
Pull the tube and lower bearing (3) into position in the draft
frame with tooling (C) until the bearing is even with the
bottom surface of the frame.
4.
Use tool group (D) and a press to install bearings (6) in link
assembly (5).
5.
Put link assembly (5) and the shims in position on the hitch.
Install shaft (7), plate (4) and the bolts.
6.
Put link assembly (8) and the shims in position on the draft
frame.
7.
Install shaft (10), plate (9) and the bolts.
8.
Install the fitting in the bottom of shaft (10).
9.
Put shims (13) as needed and steering cylinder rod (12) in
position and install shaft (1I). Install the plate and bolts to
hold shaft ( 11) and install the fitting in the bottom of the
shaft.
10.
Put clean grease in the fittings for the steering system.
3-301
