TM 5-3805-260-24
CRANKSHAFT
REMOVE CRANKSHAFT REAR SEAL AND WEAR
SLEEVE
Remove the crankshaft rear oil seal with the 1P3075
Puller Group.
REMOVING REAR OIL SEAL
Install a 5P7338 Distorter Ring from the 5P7318 Wear
Sleee Distorter Group, in the rear seal bore.
REMOVING REAR WEAR SLEEVE
(Typical Example)
Install 5P7312 Distorter between distorter ring and wear
sleeve. Turn the distorter until the edge of the tool
makes a flat place (crease) in the wear sleeve. Do this
in two or more places until the wear sleeve is loose.
Remove the tools and wear sleeve.
INSTALL CRANKSHAFT REAR SEAL AND
WEAR SLEEVE
The crankshaft rear seal and wear sleeve must be
installed at the same time. Clean the wear sleeve inside
diameter and the crankshaft outside diameter and put 6
Quick Cure Primer on the surfaces. Put 9S3265
Retaining Compound on the outside diameter of the
crankshaft and the inside diameter of the w-car sleeve.
Install 5P290 locater on the rear of the crankshaft. Put a
sealer
on
the
outer
metal
case
of
the
seal.
Put the wear sleeve and seal in position on the locater.
with the outside diameter bevel of the , wear sleeve
away from the crankshaft. Be sure the lip of the seal is
toward the engine. Put 5P7293 Installer in position on
the locator. Put clean engine oil on the face of the nut
and install it on the locator. Tighten the nut until the
installer will no longer move.
INSTALLING CRANKSHAFT REAR SEAL AND WEAR
SLEEVE
CRANKSHAFT FRONT OIL SEAL INSTALLATION
1. Put the seal over the short end of 5P4194 Installer
Assembly (A). Put a sealer on the outer diameter of
the seal metal shell. The lip of the seal must be
toward the Inside of the engine.
2. Put the seal and Installer assembly (A) in position on
the end of’ the crankshaft. Install bolt (1) and washer
(2) that hold the crankshaft pulley in place. Tighten
bolt (1) Tighten the installer assembly (A) makes
contact with the crankshaft gear.
NOTE. If a new wear surface for the front seal is
needed, put the 5P4230 Spacer between the seal and
flange of the installer assembly)
3-388
