STEER AXLE AND WHEEL
(1). Do the steps that follow for steer wheel bearing adjustment:
a. Tighten nut (1) slowly to 70 N m (50 Ib. ft. ) while turning the wheel.
b. Loosen nut (1) completely. Tighten it again to 50 5 N-m (37 + 4 lb. ft.
)
c. Bend the lock over nut (1).
(2)
Add or remove shims (4) until torque required to turn knuckle assembly
is. ..................................................................... 4. 5 to 6. 8 N-m (40 to
60 Ib. i n. )
(3)
Torque for nut that holds wheel
to hub440 + 35 N-m (325 + 25 Ib. ft. )
(5)
Torque for cover bolts
(four). .....................................................................135 14 Nm (100 10
b. ft. )
(6)
Torque for cover bolts
two ...........................................................................270 2 0 N-m (200 15
lb. ft. )
(7)
Adjust stop bolt to get angle (Y) of ..........................76
(8)
Torque for steering cylinder mounting bolts ............. 470 45 Nm (350 35 b. ft. )
(9)
Adjust stop bolt to get angle (X) of .............56
5-10
