MWO 5-2350-262-35-2
1
2
LEFT SIDE
OF VEHICLE
3
DRIVER'S
COMPARTMENT
8
4
5, 6, 7
Figure 2-5. MCU Installation on
Base and Support Bracket Assembly.
c. Assembly and Installation of MCU Wiring Harness, Grommet and Grommet Plate and Coolant Umbilical
and Umbilical Bypass Control Assembly (BCA):
CAUTION
Avoid crimping coolant umbilical.
NOTE
1. Position the MCU wiring harness (12491610) (2) against the outside of the MCU coolant
umbilical (LSF00664) (1) as shown in Figure 2-6 below.
2. Slide the grommet plate (12475741) (4) and grommet (MS35489-114) (3) over MCU end of coolant
umbilical (1) and positive electrical lead of MCU wiring harness (2). Slide grommet (3) and grommet plate (4)
towards the Bypass Control Assembly (BCA) (5) end of the coolant umbilical.
3. Insert grommet (3) into the grommet plate (4).
3
4
2
5
1
Figure 2-6. Assembly of
MCU Wiring Harness, Grommet and Grommet Bracket on
MCU Umbilical.
2-7