MWO 5-2350-262-35-2
NOTE
Step 4 below applies to Figure 2-7.
4. For vehicles equipped with MCS preparation kit only, remove screw (1), washer (2), and MCS prep spacer
plate (4) from the upper left rear corner of driver's compartment and the angle plate (3) from the left front side
of the radio box case. Discard MCS prep spacer plate, angle plate, and attaching hardware.
2
3
1
4
HATCH COVER CLOSED
FOR ART CLARITY
CAUTION
Avoid crimping coolant umbilical.
NOTE
Steps 5 and 6 below apply to Figure 2-8.
5. Slide the assembled coolant umbilical (2), MCU end first, through the MCS preparation hole (1) at the upper
left rear corner of the driver's compartment and toward the rear of vehicle with the MCU wiring harness (3)
and assembled grommet (4) and grommet plate (5).
6. Fasten the grommet plate (5) (with the angled corner in the upper left rear corner of compartment) to the rear
wall of the driver's compartment (6) using two lock washers (MS35335-33) (7) and pan head machine screws
(MS35206-281) (8).
2
3
4, 5
1
5
6
7, 8
2-8
