TM 5-3800-205-10-1
TROUBLESHOOTING PROCEDURES - CONTINUED
0012 00
Table 2. Transport Mode Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CH-47 HELICOPTER TRANSPORT - CONTINUED
6.
Poor and/or No Braking
(After
Check air connection on right
Reconnect air connection, if
Machine Assembly).
side of draft frame for leaks and/
required. If problem still exists,
or loose connection.
refer to AIR SYSTEM AND
BRAKES troubleshooting (WP
7.
Poor
Steering
(After
Machine
1. Check that locking collars and
Remove locking collars and hose
Assembly).
hose wrapping are removed
wrapping from cylinders, if
required. If problem still exists,
from cylinders.
refer to STEERING trouble-
shooting (WP 0011 00).
2. Check that hitch
locking
Remove hitch locking blocks, if
blocks are removed.
required. If problem still exists,
refer to STEERING trouble-
shooting (WP 0011 00).
8.
Rear Blackout Drive Light Does Not
Check electrical connectors on
Reconnect electrical connec-
Operate (After Machine Assembly).
right side of draft frame for loose
tions, if required. If problem still
connections.
exists, refer to ELECTRICAL
SYSTEM troubleshooting (WP
9.
Rear Blackout Drive Marker Light
Check electrical connectors on
Reconnect electrical connections
Does Not Operate (After Machine
right side of draft frame for loose
if required. If problem still exists,
Assembly).
connections.
refer to ELECTRICAL SYSTEM
troubleshooting (WP 0011 00).
10. Skid Steer Control Inoperative.
Check for blown fuse at fuse/
If fuse is bad, request a
circuit breaker panel in cab.
replacement fuse from Unit
Maintenance. If fuse is good, and
problem still exists, notify Unit
Maintenance.
11. Stoplights Do Not Operate (After
Check electrical connectors on
Reconnect
electrical
con-
Machine Assembly).
right side of draft frame for loose
nections, if required. If problem
connections.
still exists, refer to ELECTRI-
CAL SYSTEM troubleshooting
12. Taillights Do Not Come On (After
Check electrical connectors on
Reconnect
electrical
con-
Machine Assembly).
right side of draft frame for loose
nections, if required. If problem
connections.
still exists, refer to ELECTRI-
CAL SYSTEM troubleshooting
13. Windshield Wiper Motor Inoperative
1. Check wiper motor electrical
1. Reconnect electrical con-
(After Machine Assembly).
connectors
for
loose
nectors, if required. If problem
connections.
still exists, go to test step 2.
