TM 5-3800-205-10-1
TROUBLESHOOTING PROCEDURES - CONTINUED
0012 00
Table 2. Transport Mode Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
C-130 AIRCRAFT TRANSPORT
1.
Bowl Operation is Erratic, After
Check if load transfer relief valve
If load transfer relief valve and
Installation of Load Transfer Relief
and hose assembly is properly
hose assembly is properly
Valve and Hose Assembly.
installed (WP 0018 00).
installed and problem still exists,
notify Unit Maintenance.
Check hydraulic hoses at draft
Reconnect hydraulic hoses if
2.
Bowl Operation is Erratic, After
Removal of Load Transfer Relief Valve
frame for proper connections
required. If problem still exists,
and Hose Assembly.
refer to SCRAPER SYSTEM
troubleshooting (WP 0011 00).
3.
Poor
Steering
(After
Machine
Check that locking collars and
Remove locking collars and hose
Assembly).
hose wrappings are removed
wrappings from cylinders, if
required. If problem still exists,
from steering cylinders.
refer
to
STEERING
troubleshooting (WP 0011 00).
1. Reconnect
electrical
4.
Windshield Wiper Motor Inoperative
1. Check wiper motor electrical
connectors if required. If
(After Machine Assembly).
connectors
for
loose
connections (WP 0018 00).
problem still exists, go to test
step 2.
2. Check for blown fuse.
2. If fuse is bad, request a
replacement fuse from Unit
Maintenance. If fuse is good,
refer
to
ELECTRICAL
SYSTEM
troubleshooting
5.
Windshield Washer Inoperative (After
1. Check that fluid hose is
1. Install fluid hose, if removed.
Machine Assembly).
installed (WP 0018 00).
If problem still exists, go to test
step 2.
2. Check fluid reservoir inside
2. If reservoir is empty, fill
engine compartment.
reservoir (WP 0014 00). If
problem still exists, go to test
step 3.
3. Check for blown fuse.
3. If fuse is bad, request a
replacement fuse from Unit
Maintenance. If fuse is good,
refer
to
ELECTRICAL
SYSTEM
troubleshooting
6.
Windshield Wiper Motor Operates But
Check that pivot and drive shaft
Tighten pivot and drive shaft
Wiper Arm Will Not Move (After
nuts are tight (WP 0018 00).
nuts, if required. If problem still
Machine Assembly.
exists, notify Unit Maintenance.
