TM 5-3800-205-10-1
AIRDROP BY C-130 AIRCRAFT - CONTINUED
0019 00
CONFIGURE MACHINE FOR AIRDROP - CONTINUED
19.
Stow 54 in. pry bar on rear deck of scraper as follows.
a.
Place pry bar in top holder, then place in bottom holder.
b.
Secure pry bar with pin through bottom holder.
TOP
HOLDER
54 IN.
PRY BAR
PIN
BOTTOM
HOLDER
20.
CAUTION
Exhaust pipe must be taped closed to prevent wind from entering exhaust system and causing turbocharger
to spin without the benefit of lubrication. Failure to cover exhaust pipe may damage turbocharger.
21.
Use duct tape (Item 22, WP 0026 00) to cover exhaust extension.
22.
23.
Stow the following tools, required for machine assembly after airdrop, in BII toolbox on rear deck of scraper:
a.
bar, breaker, 1/2 in. drive;
b.
extension, socket, 1/2 in. drive, 5 in. long;
c.
socket, 1/2 in. drive, 9/16 in.;
d.
socket, 1/2 in. drive, 15/ 16 in.;
e.
tool, tire repair;
f.
wrench, combination, 7/16 in. (2);
g.
wrench, combination, 1/2 in.; and
h.
wrench, combination, 9/16 in.
24.
Ensure all compartment doors and BII toolbox on rear deck of scraper are closed, latched, and secured with padlocks.
25.
Position machine on airdrop platform that has been suitably prepared.
0019 00-24